Canning pulled pork in barbecue sauce
Sunday was a pulled pork day in the kitchen. I cut a big pork shoulder into chunks, lined up everything for the sauce, and by the afternoon I had seven pints of barbecue pork cooling on a towel ;)
I canned a batch back in March and opened a jar for a pulled pork burger during my pantry challenge. The shelf was looking a little empty after that, so it was time for a fresh batch. Here's exactly how I make it, so you can fill your own shelf too.
Recipe
Adapted from the BBQ Pulled Pork recipe in my Ball canning book.
Makes 7 pints (500 ml jars) for me. The book says about 6, so have an extra jar ready just in case.
Ingredients
1 boneless pork shoulder (Boston butt), 4 to 5 lb (2 to 2.25 kg), cut into large chunks
1 1/2 cups (375 ml) chopped onion, about 1 large onion
1 1/2 cups (375 ml) ketchup
1/2 cup (125 ml) light brown sugar, firmly packed
1/4 cup (60 ml) apple cider vinegar (5% acidity)
2 tbsp (30 ml) Worcestershire sauce
2 tbsp (30 ml) brown mustard
2 tbsp (30 ml) honey
3 garlic cloves, minced

Equipment
Pressure canner with its rack
7 pint (500 ml) jars with new lids and bands
A large stainless steel or enameled pot
Ladle, canning funnel and jar lifter
A chopstick or bubble tool, and a clean damp cloth for the rims
Step by step
1. Get the canner going first. I set the rack in the bottom, pour in about 2 inches (5 cm) of water and let it warm up while I work. My clean jars stay hot until I need them.
2. Make the sauce. Everything except the pork goes into the big pot: onion, ketchup, brown sugar, vinegar, Worcestershire sauce, mustard, honey and garlic. I stir until it's one smooth, dark sauce.

3. Add the pork. In go the chunks, and I turn them over until every piece is coated. I bring it up to a boil, then lower the heat and let it bubble gently for about 5 minutes. The pork doesn't need to be cooked through here, the canner takes care of that. I keep the pork in chunks and only shred it later, when I open a jar.

4. Fill the jars. I ladle the hot pork and sauce into one hot jar at a time, leaving 1 inch (2.5 cm) of headspace. Then I run a chopstick around the inside to release air bubbles, wipe the rim clean, put on the lid and screw the band on just fingertip-tight. Each jar goes straight onto the rack in the canner before I fill the next one.

5. Pressure can. With the lid locked on, I turn the heat to medium-high and let steam pour out of the vent for a full 10 minutes before closing it with the weight (or petcock, on a dial-gauge canner). Once it's up to pressure, I start the timer: pints get 75 minutes. I canned mine at 12 to 15 psi, which is right for our altitude in Catalonia (about 2,273 feet). The book's pressures (10 psi with a weighted gauge, 11 psi with a dial gauge) are for 1,000 feet or lower, so use the pressure for your own altitude and gauge type.
6. Let it cool down slowly. When the time is up, I turn off the heat and leave the canner alone until the pressure is back to zero. I wait another 5 minutes, take off the lid, and give the jars 10 more minutes in the canner before lifting them out onto a towel. Then they sit undisturbed overnight while the lids ping, and I check every seal the next day.

When I open a jar
I tip the jar into a saucepan, bring it to a boil and let it simmer for a while so the sauce thickens. Then I pull the pork apart with two forks right in the pan and pile it onto a toasted bun. Seven more pints on the shelf, ready for an easy dinner whenever we need one.
How I keep it safe
Pork is a low-acid food, so it always goes in a pressure canner, never a water bath. I stick to the tested 75 minutes for pints and set the pressure for our altitude. These are the guides I use:




Comments